Mon-Fri: 7AM-8PM, Sat: 8AM-6PM, Sun: 9AM-5PM Licensed & Insured [email protected] Serving Angwin, CA

Screw Drive Opener Repair in Angwin, CA

Screw-drive openers cleaned, lubricated and repaired. Typical cost $125-$350.

Screw Drive Opener Repair is one of the most common calls we get. A technician will explain what is wrong and what it will cost before starting, and test the door before leaving. Screw-drive openers cleaned, lubricated and repaired.

When to call for screw drive opener repair

  • The motor runs but the door doesn't move
  • Squealing from the rail
  • Slow or jerky travel, especially in cold weather

Common causes

  • Worn trolley or coupler
  • Dry or dirty screw rail
  • Temperature swings affecting the rail

What you can check yourself

  • Look for grime and dried grease along the threaded rod.
  • Only use the lubricant the manufacturer recommends for the screw rail.

Still stuck? Our free symptom checker and troubleshooting wizard walk you through it step by step.

What happens during the visit

  1. Inspect the screw, trolley and motor coupler
  2. Clean and lubricate the rail
  3. Replace worn trolley or coupler parts
  4. Set the limits and force
  5. Test the opener

How much does screw drive opener repair cost?

$125-$350Typical range, parts & labor
about 1 hourTypical time on site

What moves the price:

  • Drive type: chain, belt, screw or wall-mount
  • Whether the fix is a part or a whole new opener
  • Remotes, keypads and smart accessories
  • Ceiling height and rail extensions

These are typical U.S. ranges, not a quote. You get an exact price for your door before any work starts. For a quick estimate, try the repair cost calculator.

Serving Angwin, CA and nearby towns

Outages are common in California during heat waves and planned power shutoffs, which is why a battery backup on the opener matters here.

California law (SB 969) requires garage door openers sold or installed in the state since July 1, 2019 to have a battery backup, so the door still works during a power outage.

Technicians serve all of Angwin (ZIP code 94508), plus Saint Helena (5 mi), Calistoga (7 mi), Yountville (13 mi) and Larkfield-Wikiup (16.8 mi). Call (833) 435-8883 to book a visit in Angwin.

Screw Drive Opener Repair: frequently asked questions

How much does screw drive opener repair cost in Angwin, CA?

Screw Drive Opener Repair typically costs $125-$350 including parts and labor, and usually takes about 1 hour. The exact price depends on your door and the parts it needs, and you get it before any work starts. Call (833) 435-8883 for a quote.

Can you do screw drive opener repair the same day?

Often, yes. When a technician is available we can usually come the same day, and common parts are carried on the truck. Doors that won't close or have a broken spring are treated as priority calls, and emergency service is available.

Is screw drive opener repair covered by a warranty?

Our work comes with a 90-day labor warranty on repairs. New parts and doors also carry the manufacturer's warranty. Ask for the warranty details in writing with your quote.

Are your technicians licensed and insured?

Our technicians are insured, and where California or Angwin requires a contractor license for garage door work, the job is done under that license. You're welcome to ask for proof when you book.

Should I repair or replace my opener?

A good rule of thumb: if the repair costs more than about 50% of a replacement, or the opener is near the end of its life, replace it. Most openers last 10 to 15 years. If yours is older than that, lacks photo eyes or rolling-code security, or needs a logic board or motor, a new opener is often better value. Springs are the exception: a broken spring is always replaced, never repaired. Our free repair vs. replace calculator can help you compare.

More services

Popular Garage Door Services in Angwin, CA

Rolling Steel Door Repair

Rolling steel service doors, curtains, guides and springs repaired.

Typical $300-$1,500

Ryobi Opener Gear & Sprocket Replacement

Ryobi's garage door opener can use the brand's 18V ONE+ batteries as backup power and has accessory ports for add-ons.

Typical $125-$275

Northwest Door Garage Door Cable Repair

Frayed, snapped or slipped lift cables replaced and the door re-leveled.

Typical $150-$350

Loading Dock Door Repair

Dock doors, seals and bumpers repaired to keep shipping moving.

Typical $300-$1,200

Holmes Garage Door Garage Door Roller Replacement

Worn steel or plastic rollers swapped for quiet, sealed nylon rollers.

Typical $150-$350

Wayne Dalton Garage Door Repair

Wayne Dalton is part of the Overhead Door Corporation. Many Wayne Dalton doors use the TorqueMaster spring system, with the springs sealed inside the torsion tube, so spring work needs TorqueMaster parts and a different procedure.

Typical $150-$450

Hörmann Garage Door Sensor Repair

Photo-eye sensors realigned, rewired or replaced so the door closes reliably.

Typical $100-$250

Noisy Garage Door Repair

Squeaks, grinding and rattles tracked down and fixed for good.

Typical $100-$300

Ryobi Garage Door Opener Installation

Ryobi's garage door opener can use the brand's 18V ONE+ batteries as backup power and has accessory ports for add-ons.

Typical $350-$800

Garaga Garage Door Track Repair

Garaga is a Canadian garage door manufacturer based in Quebec.

Typical $150-$400

Haas Door Extension Spring Replacement

Haas Door, based in Wauseon, Ohio, makes residential and commercial sectional and rolling doors.

Typical $150-$350

Marantec Opener Gear & Sprocket Replacement

Marantec is a German manufacturer of residential and commercial door openers.

Typical $125-$275

Garage door stuck, noisy or broken?

Talk to a garage door technician in Angwin, CA now. Tell us what the door is doing and we'll give you a price and an arrival window.

Call NowFree Quote